Filter
Top Products
Page 7SKU 03664 For technical questions, please call 1-800-444-3353.
Warning: The Torch Handle is now active. Do not touch anything grounded while per-
forming the next step.
11. While holding the Torch Handle away from any grounding points, press and hold the
Trigger Switch to begin feeding the welding wire through the Torch Cable until it
reaches the Torch Head.
Turn the Wire Feed Speed Control clockwise to increase the wire feed. If the wire is
not feeding properly, It may also be necessary to increase the tension of the Wire
Tension Control knob by turning it clockwise.
12. Release the Trigger Switch and flip the Power Switch to the OFF (0) position.
13. Close all unit compartment doors. The unit is now ready for welding.
Operation
Controls and Indicators
Wire Routing
Housing
Wire Feed Axis
Mechanism
Torch Handle
Trigger Switch
Nozzle
Wire Spool
Ground Clamp
Welding Current
Adjustment Knob:
30~200 Amps
Wire Feed Speed Control
Overheating Indicator - Red
Trigger Switch On Indicator -
Green
Argon/CO
2
Gas
Hose Connector
Power Switch
REV 03/05