Filter
Top Products
Page 9SKU 03664 For technical questions, please call 1-800-444-3353.
Note: If too much current is drawn from the MIG Welder, the Thermal Overload protector will
activate, the red Overheating indicator will light, and the Arc Welder will turn off until it cools
down. If this happens, turn the Power Switch to the OFF (0) position and wait about 3 ~ 5
minutes.
10. When the weld is complete, lift the Torch Handle electrode wire clearly away from any
grounded object, lift your Face Shield, and turn the Power Switch to the OFF (0)
position.
11. Unplug the Power Cord from the electrical outlet.
Maintenance
Warning: Before performing any maintenance on the MIG Welder, unplug the Power Cord
from the electrical outlet.
1. Periodically using compressed air, open the top and side panels and blow out all dust
from the interior.
2. Store the unit in a clean and dry location.
3. Periodically clean out the Torch Head.
Replacing the Wire Reel
When the wire on the Feed Reel is used up, you will need to replace it as described on
page 6, step 6 through step 13.
Parts List
traPnoitpircseDtraPnoitpircseDtraPnoitpircseD
1esaC71loopSeriW23lenaP
2revoCgnidloF81ekarB
33
/lortnoCnoisneTeriW
kcoL
3revoCtneV91naF
4revoClioC02lenaPtnorF43leehWlortnoCdeeF
5revoCremrofsnarT12yalpsiDDEL53rotcelloCtnerruC
6bonKgnitsujdAtnerruC22hctiwSrewoP63sleehW
7remrofsnarTniaM32lortnoCdeepSeriW73eldnahthgiR
8draoBtiucriC42bonKdeepSeriW83eldnahtfeL
9draoBedoiD52tekcarBeldnaH93reggirT
01retratS62eldnaH04ebuTelzzoN
11elttorhT72droCeniLtupnI14piT
21pmalCdnuorG82feileRniartSelbaC24elzzoN
31elbaCdnuorG
92
yssAesoH&hcroT
)44-73strapsniatnoC(
34piT
41lanimreTdnuorG44droC
51reniateR03rotoMcirtcelE
54
"230.foloopS.bL1
eriWgnidleW
61lenaPkcaB13lenaP
REV 06/05