Filter
Top Products
9
Using the Device
Configuring the Device
The device attaches to the left side of the printer. There is a menu in the
printer’s Control Panel called CONFIGURATION OF STKR where you can change
the default offset and default stapler actions.
Note The network administrator can limit access to the offset and default stapler
actions.
Offset actions
Offset Action: No When the Job Offset mode is off, all of the jobs are
stacked with no separation.
Offset Action: Yes When the Job Offset mode is on, the device automatically
separates complete jobs or mopies (multiple original prints
of a single job). Each job or mopy is separated by offsetting
the jobs from each other.