Hitachi C 10FSB Saw User Manual


 
26
Cutting method of crown molding without tilting the saw blade.
(1) Crown molding Stopper (L) and (R) (optional
accessories) allow easier cuts of crown
molding without tilting the saw blade. Install
them in the base both-sides side to be shown
in Fig. 45-a. After inserting Tighten the 6mm
knob bolts to secure the crown molding
Stoppers.
[Optional accessories used]
Crown molding Vise Ass’y (Include Crown
molding Stopper (L))
Crown molding Stopper (L)
Crown molding Stopper (R)
(2) The crown molding vise (B) (Optional
accessory) can be mounted on either the left
fence (Fence (B)) or the right fence (Fence (A)).
It can unite with the slope of the crown molding
and vice can be pressed down.
Then turn the upper knob, as necessary, to
securely attach the crown molding in position.
To raise or lower the vise assembly, first loosen
the 6mm knob bolt. As shown in Fig. 45-b, the
vise shaft has three locking grooves into which
the tip of the 6mm wing bolt is designed to fit
in order to lock the screw holder in the desired
position.
To ensure that the tip of the 6mm wing bolt is
properly aligned with the desired locking
groove on the vise shaft, simply align the upper
surface of the fence to either of three v-grooves
on the vise shaft surface or to the lower surface
of the screw holder.
Therefore, the vise assembly can be attached in either of three positions to ensure
proper height adjustment.
After adjusting the height, firmly tighten the 6mm wing bolt; then turn the upper knob,
as necessary, to securely attach the crown molding in position. (see Fig. 45-b)
WARNING: Always firmly clamp or vise to secure the crown molding to the fence;
otherwise the crown molding might be thrust from the table and cause
bodily harm.
Do not bevel cutting. The main body or saw blade may contact the sub
fence, resulting in an injury.
Fig. 45-b
Fig. 45-a
6mm
Knob Bolt
6mm
Wing Bolt
Crown molding
Stopper (R)
(optional
accessories)
Crown molding
Vise Ass’y
(optional
accessories)
6mm
Knob Bolt
Crown molding Stopper (L)
(optional accessories)
Fence
6mm wing bolt
Crown molding
Crown molding Stopper (L)
Crown molding Stopper (R)
(optional accessories)
6mm Knob Bolt
Knob
V-Groove
Groove
Crown molding Vise Ass’y
(optional accessories)
01Eng_C10FSH_Eng 3/29/07, 12:30 PM26