Filter
Top Products
4
PRECAUTION ON USING SLIDE COMPOUND MITER SAW
1. Review this Manual and familiarize yourself with the safety rules and operating
instructions for this POWER TOOL before attempting to use it.
2. Always confirm that the POWER TOOL is clean before using it.
3. Always wear snug-fitting clothing, non-skid footwear (preferably with steel toes) and
eye protection when operating the POWER TOOL.
4. Always handle the POWER TOOL carefully. If the POWER TOOL falls or strikes against
a hard object, it might become deformed or cracked or sustain other damage.
5. Always cease operating the saw at once, if you notice any abnormality whatsoever.
6. Always confirm that all components are mounted properly and securely before using
the tool.
7. When replacing the saw blade, always confirm that the rpm rating of the new blade is
correct for use on this tool.
8. Always shut off the power and wait for the saw blade to completely stop rotating before
undertaking any maintenance or adjustments.
9. During slide cutting, always push the saw blade away from the operator.
10. During miter or bevel cutting, always wait for the rotation of the blade to stop completely
before lifting the saw blade.
11. Always make a trial run first before attempting any new use of the saw.
12. Always handle the saw blade with care when dismounting and mounting it.
13. Always confirm that the workpiece is free of nails or other foreign objects before
beginning a cut.
14. Always keep your hands out of the path of the saw blade.
15. Always confirm that the lower guards are in the proper places before using the saw.
16. Always confirm that the lower guards do not obstruct the sliding motion of the saw
before attempting slide cutting.
17. Inspect the tool power cords periodically.
18. Always confirm that the motor air vents are fully open before using the tool.
19. Always wait until the motor has reached full speed before starting a cut.
20. Never use the POWER TOOL for applications not specified in the instruction manual.
21. Never operate the tool while wearing loose clothing, a necktie or jewelry, or while your
hair is uncovered, to protect against getting caught in the moving machinery.
22. Never remove any safety devices or blade guards; use of the tool without them would
be hazardous.
23. Never lock the lower guards; always confirm that it slides smoothly before using the
tool.
24. Never damage the power cord of the tool.
25. Never attempt to move a plugged-in POWER TOOL while your finger is on the starting
switch.
26. Never use the POWER TOOL near flammable liquids or gases because sparking can
cause an explosion.
27. Never clean plastic components with solvents because the plastic may dissolve.
28. Never raise the saw blade from the workpiece until it has first come to a complete stop.
29. When slide cutting, never pull the handle toward the operator, since this could cause
the saw blade to kick up from the workpiece. Always push the handle away from the
operator in a single, smooth motion.
01Eng_C10FSH_Eng 3/18/09, 20:014