Filter
Top Products
–
19
–
English
CUTTING OPERATIONS
There are two basic types of cuts: ripping and
crosscutting. Ripping is cutting along the length and the
grain of the workpiece. Crosscutting is cutting either
across the width or across the grain of the workpiece.
Neither ripping nor crosscutting may be done safely
freehand. Ripping requires the use of the rip fence, and
crosscutting requires the miter gauge.
B
efore using the saw each and every time, check
the following:
1. The blade is tightened to the arbor.
2. The bevel angle lock knob is tight.
3. If ripping, the fence is locked into position & is
parallel to the miter gauge groove.
4. The blade guard is in place and working properly.
5. Safety glasses are being worn.
The failure to adhere to these common safety rules, and
those printed in the front of this manual, can greatly
increase the likelihood of injury.
WARNING
Fig.
T
NOTE
: Always use a push stick. When width of the rip is
narrower than 2” the push stick cannot be used because
the guard will interfere…therefore, use the auxiliary
fence so the push stick can be used as shown on page
25.
7. Keep your thumbs off the table top. When both of
your thumbs touch the front edge of the table (2),
fi nish the cut with a push stick. To make an additional
push stick, use the pattern on page 25.
8. The push stick (3) should always be used. (Fig. U)
9. Continue pushing the workpiece with the push
stick (3) until it passes through the blade guard and
clears the rear of the table.
10.Never pull the piece back when the blade is turning.
Turn the switch OFF. When the blade completely
stops, you can then remove the workpiece.
Fig.
U
BEVEL RIPPING
This cut is the same as ripping except the blade bevel
angle is set to an angle other than “0°”.
RIPPING SMALL PIECES
To avoid injury from the blade contact, never make cuts
narrower than 1/2” wide.
1. It is unsafe to rip small pieces. Instead, rip a larger
piece to obtain the size of the desired piece.
2. When a small width is to be ripped and your hand
cannot be safely press between the blade and the
rip fence, use one or more push sticks to move the
workpiece. Always use a push stick during ripping
operations.
RIPPING (FIG. T, U)
To prevent serious injury:
•
Never use a miter gauge when ripping.
•
Never use more than one r
ip fence during a
single cut.
•
Do not allow familiarity or frequent use of your
table saw to cause careless mistakes. Remember
that even a careless fraction of a second is
enough to cause a severe injury.
•
Keep both hands away from the blade and clear
from the path of the blade.
•
The workpiece must have a straight edge against
the fence and must not be warped, twisted, or
bowed when ripping.
1. Remove the miter gauge and store it in the “storage”
compartment in the base of the saw.
2. Secure the rip fence to the table.
3. Raise the blade so it is about 1/8” higher than the top
of the workpiece.
4. Place the workpiece fl at on the table and against the
fence. Keep the workpiece away from the blade.
5. Turn the saw ON and wait for the blade to come to
full speed.
6. Slowly feed the workpiece into the blade by pushing
forward only on the workpiece section (1) that will
pass between the blade and the fence. (Fig. T)
AVOID KICKBACK
by pushing forward on the section
AVOID KICKBACK by pushing forward on the section AVOID KICKBACK
of the workpiece that passes between the blade and the
fence. Never perform any freehand operations.
WARNING
WARNING
3
2
1
1