Filter
Top Products
English
23
Switch Trigger
Switch Lock
(Be used as both
Switch Lock and
Light Switch)
CAUTION:
● Don’t remove circular saw from workpiece during a cut while the saw blade is
moving.
● Pull out the battery after completing operation.
NOTE:
Take care not to lock the motor. If the motor is locked, immediately turn the power off. If
the motor is locked for a while, the motor or battery may be burnt.
1. Operation of switch (switch trigger and light switch)
(1) For safe operation of the machine, a
“switch lock” is provided on the side of a
handle.
If the “switch lock” is pulled in a state
where it is pressed in the direction of the
arrow mark, the main switch can be
turned ON.
And the “switch lock” is used as the “light
switch”. If the “switch lock (light switch)”
is pulled in a state, the light is turned ON.
(2) After the switch is turned ON, even when
you release your hand from the switch
lock, the saw blade continues running
and the light continues being turned ON
as long as you keep on pulling the switch
trigger.
(3) If you release the switch trigger, you can turn OFF the switch and the “switch lock” returns
to the original position automatically and the light turns OFF too.
NOTE:
If the saw is set aside with the battery still installed, then depending on the orientation of
the saw, if the “Switch Lock” comes in contact with the floor surface or wall surface, the
light can remain on continuously. Please be aware that if the light is allowed to remain
on continuously, even a fully charged battery can be completely discharged in about 3
hours.
2. Working performance per single charge (Reference data)
⅜ Cutting capability differs according to the condition of lumber, type of saw blade, ambient
temperature, battery characteristics, etc.
To improve working efficiency per single charge,
⅜ Minimize operation (no-load operation) other than cutting;
Wood Capacity
2 × 8 (Spruce-Pine-Fir) 85 (cuts)
Concreteform plywood (1/2” (12 mm) t) 148 ft (45 m)
Fig. 17