Filter
Top Products
12
English
6. Confirm the position of the spindle lock before using the tool.
After installing the saw blade, confirm that the spindle lock has
been returned to the retract position before using the power tool
(see Fig. 5).
WARNING: Do not push the spindle lock during rotation.
Also, do not switch it on while pushing the
spindle lock (in the state where the tipped saw
spindle is fixed).
Fig. 5
7. Check facial deflection by rotating the saw blade.
If there is too much facial deflection, the lifespan of the saw blade will be shortened and cutting precision
will deteriorate.
8. Check the Power Receptacle.
To prevent overheating, accidental stopping or intermittent operation, confirm that the power cord
plug fits properly in the electrical receptacle and does not fall out after it is inserted. Repair or replace
the receptacle if it is faulty.
9. Securely fix the cutting material.
Ensure that the material is securely fastened with the vise. If it is not, a serious accident could be caused
if the material comes loose or the saw blade breaks during operation.
10. Confirm the tool’s power cord is not damaged.
Repair or replace the power cord if an inspection indicates that it is damaged.
AFTER CONNECTING THE POWER PLUG TO AN APPROPRIATE AC POWER SOURCE,
CHECK THE OPERATION OF THE TOOL AS FOLLOWS:
11. Trial Run
After confirming that no one is standing behind, the power tool start and confirm that no operating
abnormalities exist before attempting a cutting operation.
12. Inspect the rotating stability of the saw blade.
For precise cutting, rotate the saw blade and check for deflection to confirm that the blade is not noticeably
unstable; otherwise vibrations might occur and cause an accident.
PRACTICAL APPLICATIONS
WARNING: Never remove or install a workpiece while the saw blade is rotating, to avoide personal
injury.
1. Switch operation
The trigger switch lock-off button is designed to prevent inadvertent
operation of the power tool. To operate the power tool, it is necessary
to first fully insert the lock-off button into the hole on the handle as
shown in Fig. 6.
The trigger switch will not operate unless the lock-off button has
been pushed in.
When the trigger switch is released, the power goes off and the
lock-off button automatically returns to its initial position, locking
the trigger switch.
CAUTION: Before plugging in the tool, always cheek to see
that the switch trigger actuates properly and
returns to the off position when released.
Fig. 6
Spindle Lock
Lock off
Button
Handle
Trigger
Switch