Filter
Top Products
English
8
(4) When you release the lever, the spring force
will return the lever to the correct position
automatically. (Fig. 6)
(5) Pull the back of the saw blade two or three
times by hand and check that the blade is
securely mounted. When pulling the blade,
you will know it is properly mounted if it clicks
and the lever moves slightly. (Fig. 7)
CAUTION:
When pulling the saw blade, be absolutely
sure to pull it from the back. Pulling other
parts of the blade will result in an injury.
7. Dismounting the blade
(1) Turn on and off the switching trigger several
times so that the lever can jump out of the
front cover completely (Fig. 2). Thereafter,
turn off the switch and unplug the power cord.
Lever
Fig. 6
Fig. 7
Blade
Lever
Blade
Fig. 5
Slit of Plunger
CAUTION:
Be absolutely sure to keep the switch turned
off and the power cord unplugged to prevent
any accident.
(2) After you have pushed the lever in the
direction of the arrow mark shown in Fig. 3,
turn the blade so it faces downward. The
blade should fall out by itself. If the blade
doesn’t fall out, pull it out by hand.
CAUTION:
Never touch the saw blade immediately after
use. The metal is hot and can easily burn your
skin.
WHEN THE BLADE IS BROKEN
Even when the saw blade is broken and remains
inside the small slit of the plunger, it should fall
out if you push the lever in the direction of the
arrow mark, and face the blade downward. If it
doesn’t fall out itself, take it out using the
procedures explained below.
(1) If a part of the broken saw blade is sticking
out of the small slit of the plunger, pull out
the protruding part and take the blade out.
(2) If the broken saw blade is hidden inside the
small slit, hook the broken blade using a tip
of another saw blade and take it out. (Fig. 8)
MAINTENANCE AND INSPECTION OF SAW BLADE
MOUNT
(1) After use, blow away sawdust, earth, sand,
moisture, etc., with air or brush them away
with a brush, etc., to ensure that the blade
mount can function smoothly.
(2) As shown in Fig. 9, carry out lubrication
around the blade holder on a periodic basis
by use of cutting fluid, etc.
Another Blade
Fig. 8
Lever
Slit of Plunger
01Eng_CR13V2_US 10/22/08, 18:088