16
English
9. Using the light
The light lights when the light switch is pushed.
When the light switch is pushed again, the light
is turned off . (Fig. 12)
Light switch
Fig. 12
CAUTION
Do not look directly into the light. Such
actions could result in eye injury.
10. Using in the straight or pistol confi guration
Use the tool in the straight confi guration when
using in confi ned spaces. Use it in the pistol
confi guration when using in other locations.
Select the confi guration that best matches
the tool application. When changing the
confi guration, the tool will make a clicking
sound when it snaps into position. Bend (or
extend) the tool until the clicking sound is
heard.
CAUTION
When using the tool in the pistol
confi guration, do not hold onto the bending
portion of the tool when returning to the
straight confi guration. Your fi nger or other
part of the hand may be pinched by the
bending portion resulting in possible injury
(Fig. 13).
Bending portion
Fig. 13
THE SCOPE AND SUGGESTIONS
FOR USES
Table 6
Work Cap position Suggestions
Drilling
Steel
Use for drilling purpose.
Aluminum
Screw tightening
Small screw 1 – 21
Use the bit and socket matching the screw
diameter.
Wood screw
1 –
Use after drilling a pilot hole.
CAUTION
● While operating the cordless driver drill,
take care not to lock the motor.
If the motor is locked, immediately turn the
power off .
If the motor is locked for a while, the motor
or battery will be burnt.
● Do not tighten too strongly as the screw
heads will be damaged.