Filter
Top Products
English
17
WARNING
● To avoid double firing or accidental
firing due to recoil.
1) Do not press the nailer against the
wood with excessive force.
2) Separate the nailer from the wood as
it recoils after nailing.
1 Set the switching device to the
downward position (to set to CONTACT
ACTUATION MECHANISM).
(Set the switching device to the
downward position completely as
shown in the diagram. Otherwise, it will
not operate properly.)
2 Pull the trigger with the Nailer off the
workpiece.
3 Depress the push lever against the
workpiece to drive a nail.
4 Move the Nailer along the workpiece
with a bouncing motion.
Each depression of the push lever will
drive a nail.
As soon as the desired number of nails
have been driven, remove finger from the
trigger.
(Set the switching device to the
upward position completely as shown
in the diagram. Otherwise, it will be
set to CONTACT ACTUATION
MECHANISM.)
2 Position the nail outlet on the
workpiece with finger off the trigger.
3 Depress the push lever firmly until it
is completely depressed.
4 Pull the trigger to drive a nail.
5 Remove finger from the trigger.
To continue nailing in a separate location,
move the nailer along the wood, repeating
steps 2 - 5 as required.
WARNING
● A nail will fire each time the trigger is
depressed as long as the push lever
remains depressed.
(2) Continuous operation (Push lever fire)
Using CONTACT ACTUATION
MECHANISM
Switching Device
1 Upward position
Switching Device
1 Downward position
Previously pull the trigger
Push Lever
4
2
Trigger
Push Lever
3
4
01Eng_NR90AD(S)_US 11/19/10, 2:16 PM17