Filter
Top Products
— 17 —
English
NAILER OPERATION
Read section titled “SAFETY”(pages 4 – 9).
DANGER
ⅷ Operators and others in
work area MUST wear
safety glasses with side
shields which conforms
to ANSI Z87.1
specifications.
ⅷ Never use in presence of
flammable liquids or
gases.
ⅷ Do not touch around the
exhaust outlet with bare
hands.
The push lever and nose
will become hot and get
heated up after
prolonged or rapid use.
ⅷ Explosion and fire hazard
Keep away from
sunshine and from
temperature exceeding
120°F (50°C).
ⅷ Keep away from ignition
source.
ⅷ No smoking.
WARNING
ⅷ NEVER point tool at
yourself or others in
work area.
ⅷ Keep fingers AWAY from
trigger when not driving
nails to avoid accidental
firing.
ⅷ Use outside or well–
ventilated area.
ⅷ Do not inhale its
contents.
ⅷ Do not use the electrical
cord if damaged.
Have it repaired
immediately.
ⅷ Never place your face,
hands or feet closer than
8 inches (200 mm) from
firing head when using.
120°F MAX
(50°C)
ⅷ Do not drive nails on the top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
ⅷ Do not drive nails into thin boards or near corners
and edges of workpiece. Nails can be driven
through or away from workpiece and hit
someone.
ⅷ Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
ⅷ Never use Nailer which is defective or operating
abnormally.
ⅷ Do not use Nailer as hammer.
ⅷ Disconnect battery and fuel cell from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
ⅷ Be careful of unwanted fastener.
If pulling the trigger more when not driving nail at
the temperature below 30°F (0°C), an wanted
fastener will be driven.
This Nailer is equipped with a FULL SEQUENTIAL
ACTUATION MECHANISM.
Explanation of FULL SEQUENTIAL ACTUATION
MECHANISM nailing operation;
First, press the push lever against the workpiece;
next, pull the trigger to drive a nail.
The machine employs a preventive mechanism for
unloaded operation.
The machine enters a state where the push lever cannot be
pushed up. This takes place when the magazine is not
loaded with nails or when the remaining number of nails
becomes less than 8 or 9.
CAUTION
ⅷ Use caution not to throw the push lever tip onto
wood when the push lever cannot be pushed up.
METHODS OF OPERATION
CAUTION
ⅷ Squeeze the trigger when drive a nail, otherwise
the piston can not return correctly.
ⅷ Make sure the nailing depth when the temperature
is above 104°F (40°C) or below 32°F (0°C).
This Nailer is equipped with the push lever and does not
operate unless the push lever is depressed (upward
position).
It is intermittent operation (Trigger fire) only.
1 Position the nail outlet on the workpiece with
finger off the trigger.
2 Depress the push lever firmly until it is completely
depressed.
3 Pull and squeeze the trigger to drive a nail.
4 Remove finger from the trigger.
To continue nailing in a separate location, move the
nailer along the wood, repeating steps 1 - 4 as
required.
01Eng_NR90GC2_US 4/13/07, 10:4817