Filter
Top Products
English
13
HOW TO INSTALL THE OPTIONAL ACCESSORIES
WARNING: Be sure to switch power OFF and disconnect the plug to avoid
accidents.
1. Installing the sponge pad (velcro type), the felt pad and the round rubber pad.
Fig. 7
CAUTION: Replace only the pad and use the other parts just as they are. The sander
will vibrate greatly if parts other than the pad are removed or exchanged.
Round
rubber pad
⅜ Loosen the four M4 × 10
screws and remove the quick
stick pad.
4-3/8” × 4”
(110 × 100 mm)
Quick stick pad
4-3/8” × 4”
(110 × 100 mm)
Sponge pad
(Velcro type),
felt pad
5” (125 mm)
round rubber
pad
⅜ Tighten the four M4 × 10
screws and attach the
sponge pad, felt pad
or round rubber pad.
Sponge pad or felt pad