Filter
Top Products
English
16
(c) Install the hook and spring on the other side
and securely fasten with screw. (Fig. 6)
NOTE:
Pay attention to the spring orientation. Install
the spring with larger diameter away from
you. (Fig. 8)
1.2 Using as an auxiliary light
(1) Press the switch to turn off the light.
If forgotten, the light will turn off automatically
after 15 minutes.
(2) The direction of the light can be adjusted within
the range of hook positions 1 - 5. (Fig. 9)
⅜ Lighting time
AAAA manganese batteries: approx. 15 hrs.
AAAA alkali batteries: approx. 30 hrs.
CAUTION:
● Do not look directly into the light.
Such actions could result in eye injury.
1.3 Replacing the batteries
(1) Loosen the hook screw with a phillips-head
screwdriver (No. 1). (Fig. 10)
Remove the hook cover by pushing in the direction
of the arrow. (Fig. 11)
(2) Remove the old batteries and insert the new
batteries. Align with the hook indications and
position the plus (+) and minus (-) terminals
correctly. (Fig. 12)
(3) Align the indentation in the hook main body with
the protuberance of the hook cover, press the hook
cover in the direction opposite to that of the arrow
shown in Fig. 11 and then tighten the screw.
Use commercially available AAAA batteries
(1.5 V).
NOTE:
Do not tighten the screw excessively. Such action
could strip the screw threads.
CAUTION:
● Failure to observe the following can result in
battery leakage, rust or malfunction.
Position the plus (+) and minus (-) terminals
correctly.
Replace both batteries at the same time. Do
not mix old and new batteries.
Fig. 11
Fig. 9
Fig. 10
Fig. 8
Larger diameter faces away
Switch
Hook
Phillips-head
screwdriver
Arrow
Hook cover
Hook main body
Protube-
rance
Inden-
tation
Fig. 12
AAAA
batteries
Indentation
Protube-
rance
Hook cover
Screw
Hook