Filter
Top Products
— 11 —
English
NAIL SELECTION
WARNING
ⅷ Be sure to use only the genuine HITACHI nails for
the NR90GC. The use of any other nails can result
in tool malfunction and/or nail breakdown,
leading to serious injuries.
Only nails shown in the Table below can be driven with
this Nailer.
* This Nailer is not recommended for use with from 3" to
3-1/2" ring shank nails in pressured-treated lumber.
SPECIFICATIONS
Input power source Single phase: AC120V 60Hz
Charging time
Approx. 60 min.
(At a temperature of 70°F (20°C))
Charging voltage DC 7.2 V
Charging current DC 1.6 A
Weight 2.4 lbs. (1.1 kg)
ACCESSORIES
DANGER
ⅷ Accessories other than those shown below can
lead to malfunction and resulting injuries.
STANDARD ACCESSORIES
1 Safety glasses............................... 1
2 Battery ........................................... 1
3 Charger ......................................... 1
4 Case ............................................... 1
5 Allen wrench for M5 screw ......... 1
1
OPTIONAL ACCESSORIES
sold separately
⅜ Fuel Cell Code No. 752-600
⅜ Gas Strip Nailer Lubricant
8 oz. (250 cc) oil feeder (Code No. 885-246)
NOTE: Accessories are subject to change without any
obligation on the part of HITACHI.
4
1.Gas Strip Nailer
Dimensions 13-21/32" × 13-29/32" × 4-1/4"
Length × Height × Width (347 mm × 353 mm × 108 mm)
Weight 7.7 lbs. (3.5 kg)
Nail capacity 37 nails (1 strip)
Cycle rate
Intermittent: 2 – 3 nails per second
Continuous: 1,000 nails per hour
Battery
EB714S (1.4 Ah)
Ni-Cd battery, 7.2 V
Fuel Cell Type No. 728-980
……
sold separately
2. Battery Charger (UC7SD)
NOTE: The charging time may vary according to temperature and power source voltage.
2" (50 mm)
3-1/2" (90 mm)
Paper collated strip nails Min. Max.
Clipped-head nails
.266"
(6.8 mm)
.303"
(7.7 mm)
.120"
(3.0 mm)
.131"
(3.3 mm)
2
3
5