Filter
Top Products
10 – English
SAFETY INSTRUCTIONS
Ground fault circuit interrupter (K3000
Wet)
Ground fault circuit interrupters are for protection in case an
electrical fault should occur.
The LED indicates that the ground fault circuit interrupter is on
and that the machine can be switched on. If the LED is not
on, push the RESET button (green).
Check the ground fault circuit interrupter
• Connect the machine to the socket. Push the RESET
button (green) and the red LED lights up.
• Start the machine.
• Push the TEST button (blue).
• The ground fault circuit interrupter should trip and the
machine switch off instantly. If not, contact your dealer.
• Reset with the RESET button (green).
Cutting blades
General
• Cutting blades are available in two basic designs;
abrasive discs and diamond blades.
• High-quality blades are often most economical. Lower
quality blades often have inferior cutting capacity and a
shorter service life, which results in a higher cost in
relation to the quantity of material that is cut.
• Make sure that the right bushing is used for the cutting
blade to be fitted on the machine. See the instructions
under the heading Assembling the cutting blade.
Suitable cutting blades
*Without water
Cutting blades for different materials
Hand-held, high-speed machines
Our cutting blades are manufactured for high-speed, portable
power cutters. If blades from other manufacturers are used,
ensure that the blades conform to all regulations and
demands that concern this type of power cutter.
Special blades
Some cutting blades are designed for stationary equipment
and for use with attachments.Such cutting blades must not be
used on portable power cutters.
Always contact local authorities and make sure you are
following applicable directives.
!
WARNING! A cutting blade may burst and
cause injury to the operator.
Never use a cutting blade at a lower speed
rating than that of the power cutter.
Never use a cutting blade for any other
purpose than that it was intended for.
Cutting blades K3000 K3000 Wet
Abrasive discs Ye s Yes*
Diamond blades Ye s Ye s
Rescue blade No No
Concrete Metal Plastic
Abrasive discs X X X
Diamond blades X