Filter
Top Products
English – 15
STARTING AND STOPPING
Starting and stopping
Before starting (K3000 Wet)
Water connector
Connect the water hose to the water supply (A). The water
flow is regulated using the water tap (B).
Ground fault circuit interrupter
Make sure the ground fault circuit interrupter is switched on.
The LED indicates that the ground fault circuit interrupter is on
and that the machine can be switched on. If the LED is not
on, push the RESET button (green).
Check the ground fault circuit interrupter. See instructions
under the heading Checking, maintaining and servicing the
machine’s safety equipment.
Starting
• Grip the front handle with the left hand.
• Grip the rear handle with your right hand.
• Press in the power switch lock with your right-hand thumb
and press in the power switch.
• Run the machine unloaded and in a safe manner for at
least 30 seconds.
Stopping
Stop the motor by releasing the power switch.
!
WARNING! Note the following before
starting:
The machine should be connected to an
earthed outlet socket.
Check that the mains voltage corresponds
with that stated on the rating plate on the
machine.
Make sure you have a secure footing and
that the cutting blade cannot touch anything.
Keep people and animals well away from the
working area.
!
WARNING! The cutting blade continues to
rotate for some time after the motor has
stopped.