Filter
Top Products
EN-2 47083068_ed1
EN
WARNING
Always turn o the air supply and disconnect the air supply hose before installing, remov-
ing or adjusting any accessory on this tool, or before performing any maintenance on this
tool.
The direction of the fan can be adjusted from horizontal to vertical be loosening the lock ring
and turning the air cap to the proper location. Hand tighten lock ring after adjustment.
Controls
Refer to illustration 47083233 on page 2.
1. Fluid Control
The uid control knob will adjust the atomization of the paint. Turn the knob clockwise until fully
closed. Then while turning the knob
counterclockwise, trigger short bursts of paint. This counterclockwise movement of the knob will
move the pattern from ne to coarse. Adjust the knob until the desired pattern is obtained.
2. Pattern Control
The pattern control knob adjusts the size of the fan. A wide fan will result if the knob is fully
opened by turning it counterclockwise. As the knob is turned clockwise, a smaller round pattern
will be achieved.
3. Air Control (If Applicable)
Open the air control knob fully by turning counter clockwise. Set desired air pressure using
regulator. Do not exceed maximum air pressure. If a lower air pressure is desired for some parts
of the spray job, turn the air control knob clockwise as needed.
Spray Patterns
If the pattern is too coarse and the uid control knob can not adjust it properly, try adjusting the
air pressure or thin the paint to achieve
desired pattern.
The spray pattern varies from round to at with patterns in between (Refer to illustration TP2051
on Page 2).
Routine Maintenance
NOTICE
Dispose of hazardous uid according to all local, state, and national guidelines.
WARNING
Always turn o the air supply and disconnect the air supply hose before installing, remov-
ing or adjusting any accessory on this tool, or before performing any maintenance on this
tool.
Clean spray gun and canisters immediately after use. Paint or other uids can dry quickly and can
easily plug internal passageways and render the spray gun useless.
WARNING
Do not use Methylene chloride (Dichloromethane) or any halogenated hydrocarbon
solvents with this spray gun.