Filter
Top Products
47083068_ed1 EN-3
EN
Remove and empty the canister. Rinse canister with a solvent recommended for the paint being
used.
Fill canister with solvent and attach to spray gun. Spray solvent into an approved container, while
shaking the gun vigorously. Continue until all traces of paint have been eliminated from spray.
Also wipe the exterior of the gun with a rag soaked with the solvent.
Remove the air cap and soak in solvent. Use a toothpick or plastic brush, to clean air passages.
NOTICE
Using metal objects can damage the precision air passages. DO NOT soak spray gun in
solvent. This can damage non-metallic
components.
NOTICE
After cleaning, lubricate lightly with NON-SILICONE OIL. Silicone oil can cause oil spots to
occur in the paint.
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air lter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-o, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16577629 and table on page 2. Maintenance frequency is shown in circular
arrow and dened as h=hours, d=days, and m=months of actual use.. Items identied as:
1. Air lter 5. Thread size
2. Regulator 6. Coupling
3. Emergency shut-o valve 7. Safety Air Fuse
4. Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, de-
greased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Oce or Distributor.