Filter
Top Products
SECTION 2—INITIAL SETUP
HomeFill
™
II Compressor 13 Part No 1100873
Transporting the Compressor
ƽ WARNING
NEVER transport a compressor with a cylinder connected
to or stored on the compressor, otherwise injury or
damage can occur.
CAUTION
When transporting the compressor, be careful not to
bump the compressor or the connectors into obstacles.
Otherwise, damage to the compressor may occur.
NOTE: For this procedure, refer to FIGURE 2.1.
1. There are two methods to
safely transport the
compressor:
A. One hand - Grasp the
hand grip at the
bottom rear of the
compressor.
B. Two hands - Grasp
the hand grips on the
sides of compressor.
FIGURE 2.1 Transporting
the Compressor
Installing the Power Cord
NOTE: For this procedure, refer to FIGURE 2.2 on page 14.
1. Ensure the compressor is on a hard flat stable surface, such
as a table or the Ready Rack.
2. Make sure the power switch is in the Off (O) position
3. Plug the power cord into the electric connector in the back
of the compressor.
Hand Grip
Hand Grip
Hand Grip