Filter
Top Products
11
Receiving
Open both shipping containers and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Read the instruction
manual thoroughly for assembly, maintenance and
safety instructions.
Contents of Shipping Containers
Container One
1 Stand with motor
Container Two
1 Saw body
1 V-belt
1 Belt cover
1 Trunnion support bracket
1 Table
2 Table lock knobs
1 Table pin
1 Table insert
1 Fastener package (see fastener page)
1 Instruction manual
1 Warranty card
Tools Required for Assembly
3/8" to 1" combination wrench set and
adjustable wrench
#1 and #2 cross point screwdrivers
Assembly
Exposed metal surfaces, such as the table, have
been given a protective coating. This should be
cleaned with a soft cloth and solvent, such as
kerosene. Do not use an abrasive pad, and do not
get solvents on plastic parts.
1. Remove belt cover from inside of stand.
2. Place cabinet stand upright on a level surface. If
desired, the stand can be further stabilized by
securing it to the floor with lag screws through
the inside corner holes. If using a mobile base,
lock the casters before assembling or operating
the band saw.
3. With the aid of a second person, lift the saw
body out of the shipping container and place
onto stand top. Be sure front of saw (with JET
logo) faces stand front (JET logo).