Filter
Top Products
13
9. The v-belt is properly tensioned when finger
pressure between the two pulleys causes
approximately 1/2" deflection (fig. 8d).
10. Screw the two small knobs (Fig. 9) into the
threaded holes in the saw body. Slide the pulley
cover down over the knobs, and tighten the
knobs.
11. Attach trunnion support to saw body with two M8
x 30 hex cap screws and two M8 lock washers
(as in item D, page two). See Figure 12.
12. Thread nut on to table stop bolt (Fig. 12) and
attach to trunnion support bracket as shown.