Filter
Top Products
Upper Blade Guide Handwheel (A, Fig. 3) -
located on the upper right side of the saw. Turn
clockwise to raisethe bladeguide assembly. Turn
counter-clockwise to lower.
Work Lamp Switch (8, Fig. 3) - on top of lamp
shade; turns lamp on and off.
Shear Lever (C, Fig. 3) - located on upper column.
UP position allows insertion of blade end into shear.
Pull lever DOWN to cut blade.
Main Motor Start Switch (A, Fig. 4) - located on
control panel. Depressto start bandsaw.
Main Motor Stop Switch (8, Fig. 4) - located on
control panel. Depress to stop bandsaw.
Power Indicator Light (C, Fig. 4) - located on
control panel. Indicatesthat power to the control
panel is on.
Key Lock Switch (0, Fig. 4) - located on control
panel. Turn to 12 o'clock position and remove key
to lock out power from the control panel. Insert key
and turn to the three o'clock positionto turn on
power to the control panel.
Emergency Stop Switch (E,Fig.4)- locatedon
the controlpanel. Pressto stopmachine.Turn90°
to reset.
Digital Readout (F, Fig.4) - located
on the control
panel. Indicates blade speed in feet per minute:
Note: after the saw is first started or the speed has
been changed, allow a least a minute for the
readout to stabilize to the new setting.
Grinder Toggle Switch (A, Fig. 5) - located on
blade welder panel found on column front. Flip
switch up to start grinder; flip down to stop grinder.
Weld Button (8, Fig. 5) - located on blade welder
panel found on column front. Depressand hold to
start welding. Shuts off automatically whenweldis
done. Release when weld is completed.
Anneal Button (C, Fig. 5) - located on blade welder
panel found on column front. Depress and hold to
anneal blade, release to stop.
Blade Clamp Pressure Knob (0, Fig. 5) - located
on bladewelderpanelfoundoncolumnfront. Sets
pressurefor differentwidthblades.
C
A
B
Fig.3
F
B
C
A
D
E
Fig. 4
B
E
D
C
A
4
Fig. 5