Filter
Top Products
8
Assembly
WARNING
The dust collector must be disconnected
from the power source during assembly.
Failure to comply may result in serious
injury!
The JET DC-650TS does not come with a
collector can. You can use the JET two stage
dust collector on a variety of round, metal and
plastic collector cans. The outer diameter of the
trash can should be approximately 20-1/4” – 24-
1/4” to fit properly.
1. Attach the deflector (A, Fig. 1) to the plastic
cover using two hex cap screws, four flat
washers and two hex nuts (B, Fig. 1).
Tighten the hardware.
2. Attach the impeller guard (C, Fig. 1) to the
plastic cover with three flat washers and
three hex nuts (D, Fig. 1). Tighten the
hardware
WARNING
To reduce the risk of injury from moving
parts, always keep impeller guard in place.
Failure to comply may result in serious
injury!
3. Slide the elbow (A, Fig. 2) over the impeller
housing exhaust, and tighten in place with
one hex cap screw, one flat washer and one
hex nut (B, Fig. 2).
4. Connect the filter (A, Fig. 3) to the elbow
and turn counter-clockwise so that it locks in
place.
WARNING
Static electricity will build up in the filter
during operation. The filter ground must be
attached to the machine ground, and to the
filter. Failure to comply may result in
fire/loss of property, or personal injury!
5. Attach the grounding clip (A, Fig. 6) to the
metal part of the filter. This will prevent
static electricity from building up in the filter.