Filter
Top Products
9
Electrical Connections
WARNING
All electrical connections must be done by
a qualified electrician. All adjustments or
repairs must be done with the dust
collector disconnected from the power
source, unplugged. Failure to comply may
result in serious injury!
The DC-650TS dust collector is rated
115V/230V, Prewired 115V.
If you want to run the DC-650TS on 230V refer to
the wiring diagram found on the inside of the
switch box cover (A, Fig. 4).
Before hooking up to the power source, make
sure that the switch is in the off position.
Turning the Machine On & Off
Note: Before hooking up to the power source,
make sure that the switch is in the off position.
1. The dust collector can be turned on by
flipping the switch (B, Fig. 4) into the on
position.
2. There is a removable key in the tip of the
switch that can be removed in the off
position. When the key has been removed
the dust collector cannot be used.
Maintenance
WARNING
Never perform maintenance on this machine
before turning switch off and removing plug
from power source, unplug.
Failure to comply may cause serious injury!
Motor
Make frequent inspections of the motor cover (C,
Fig. 4) and blow out (with low pressure air hose)
or vacuum any accumulation of foreign material
in order to maintain normal motor ventilation.