Filter
Top Products
1
6
5. Feed/Lead Selector Lever (H,Fig.13)-
located on the front of the gearbox. Used
in setting up for feeding and threading.
Positions "F" and "D" are for the feed rod.
Positions "E" and "C" are for the feed
screw. Position "0" is neutral.
6. Lock Knob (I, Fig. 13) - located on the
front of the gearbox. With the knob in the
six o'clock position, feed/lead selector
knob (J, Fig. 13) may be adjusted. With
the knob in the twelve o'clock position, the
feed/lead selector knob (J, Fig. 13) is
locked.
7. Feed/Lead Selector Knob (J,Fig.13)-
located on front of the gearbox. Used for
setting up for feeding and threading.
8. Compound Lock (A, Fig. 14) - hex socket
screw located on left side of compound.
Turn clockwise to lock and counter-
clockwise to unlock.
9. Carriage Lock (B, Fig. 14) - lock handle
located on top of carriage. Turn clockwise
to lock. Turn counter-clockwise to unlock.
Caution: carriage lock must be unlocked
before engaging automatic feeds or
damage to lathe may occur.
10. Longitudinal Traverse Hand Wheel -(D,
Fig. 14) - located on the apron assembly.
Rotate hand wheel clockwise to move the
apron assembly toward the tailstock.
Rotate the wheel counter-clockwise to
move the apron assembly toward the
headstock.
11. Feed Selector (E, Fig. 14) - located in the
center front of the apron assembly.
Pushing lever to the left and down
activates the crossfeed function. Pulling
lever to the right and up activates the
longitudinal function.
12. Half Nut Engage Lever (thread cutting)
(F, Fig. 14) - located on front of the apron.
Move the lever down to engage. Move
the lever up to disengage.
13. Cross Traverse Handwheel (G, Fig. 14) -
located above the apron assembly.
Rotate clockwise or counter-clockwise to
move, or position.
14. Compound Rest Traverse Handwheel
(H, Fig. 14) - located on the end of the
compound slide. Rotate clockwise or
counter-clockwise to move, or position.