Filter
Top Products
6
General Electrical Cautions
This saw should be grounded in accordance with
the National Electrical Code and local codes and or-
dinances. This work should be done by a qualified
electrician. The saw should be grounded to protect
the user from electrical shock.
Caution: For circuits which are far away from the
electrical service box, the wire size must be increased
in order to deliver ample voltage to the motor. To mini-
mize power losses and to prevent motor overheating
and burnout, the use of wire sizes for branch circuits
or electrical extension cords according to the follow-
ing table is recommended.
be carefully checked to determine that it will operate
properly and perform its intended function - check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condi-
tions that may affect its operation.
A guard or other part that is damaged should be prop-
erly repaired or replaced.
20. DIRECTION OF FEED. Feed work into a blade or
cutter against the direction of rotation of the blade or
cutter only.
21. NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER OFF. Don’t leave tool until it comes
to a complete stop.
22. DO NOT REMOVE JAMMED CUTOFF PIECES
until the blade has stopped.
23. MAINTAIN PROPER ADJUSTMENT of blade ten-
sion, blade guides and thrust bearings.
24. ADJUST UPPER BLADE GUIDE TO JUST CLEAR
WORKPIECE.
25. HOLD WORKPIECE FIRMLY AGAINST TABLE.
a
Minimum gage for cord
Switch Padlock
Model No. BP-1, Stock No. 709736
To safeguard your machine from unauthorized
operation and to avoid accidental starting by young
children, the use of a padlock is highly recommended.
Model BP-1 is available from your local authorized
distributor or by calling JETat 800-274-6848.
Ordering Information
Model No BP-1
Stock No. 709736
To lock the main switch in the OFF position, remove
the switch key from the switch. Place the key in a
location that is inaccessible to children and others
not qualified to use the tool.
1. Open the padlock (Fig. A).
2. Insert through holes in the start button (Fig. B).
3. Close the padlock.
4. Place the key in a safe place and out of reach
of children.
For three phases tool without locked off feature shall
have the following instruction:
The installer shall follow local regulations and
National Electrical Code, ANSI/NFPA 70 installation
requirements.
Figure A Figure B