Filter
Top Products
27
1. Remove the saw blade and the blade guard for
dado cuts ONLY. Reinstall and realign blade
guard for all through- sawing operations. Install
a dado not exceeding 6 in. diameter and 13/16
in. width.
2. Install a dado table insert making sure that the
rear of the insert is flush with the table.
Note: A dado table insert is not included but can
be ordered (SN 707001) by calling the number
on the cover of this manual.
3. Instructions for operating the dado is packed
with the separately purchased dado set.
4. The arbor (B) on this saw restricts the maximum
width of the cut to 13/16 in.
5. It is not necessary to install the outside flange (A)
before threading on the arbor nut (C) for the
maximum 13/16 in. dado cuts. Make sure that the
arbor nut (C) is tight, and that at least one thread
of the arbor sticks out past the nut.
6. Use only the correct number of round outside
blades and inside chippers as shown in the dado
set’s instruction manual. Blade/chippers must
not exceed 13/16 in. total in width.
7. Check the saw to ensure that the dado will not
strike the housing, insert, or motor when in
operation.
For your own safety, always
replace the blade, blade guard assembly, and
table insert when you are finished with the dado
operation.
Figure 42