Filter
Top Products
7
Specifications
Stock Number .......................................................................................................................... 707000
Motor ................................................................................................. 120VAC, 1PH, 60Hz, 15A, 4.4HP
Blade Speed - no load (RPM) ........................................................................................................ 4000
Saw Blade Diameter (in.)................................................................................................................... 10
Arbor Diameter (in.) ......................................................................................................................... 5/8
Blade Tilt (deg.) ...........................................................................................................................45 left
Rip Capacity (in.) .............................................................................................................................. 25
Maximum Cutting Depth at 90º (in.)................................................................................................ 3-1/8
Maximum Cutting Depth at 45° (in.) ............................................................................................... 2-1/2
Dado Capacity (in.) ................................................................................................................. 13/16 x 6
Table Height, with Stand (in.)............................................................................................................. 35
Main Table Size (in.) .......................................................................................................... 24 W x 21 D
Table Size with Side and Rear Extension Wings (in.) ..................................................... 30-1/4 W x 21 D
Table Size with Both Wings Fully Extended (in.) ....................................................... 42-3/8 W x 35-3/4 D
Dust Port Diameter (in.)................................................................................................................. 2-1/2
Gross Weight (lbs.) ......................................................................................................................... 105
Net Weight (lbs.) ............................................................................................................................... 91
Definitions and Terminology
Arbor: Metal shaft that connects the drive
mechanism to the blade.
Bevel Edge Cut: Tilt of the saw arbor and blade
between 0° and 45° to perform an angled cutting
operation.
Blade Guard: Mechanism mounted over the saw
blade to prevent accidental contact with the cutting
edge.
Crosscut: Sawing operation in which the miter
gauge is used to cut across the grain of the
workpiece.
Dado Blade: Blade(s) used for cutting grooves and
rabbets.
Dado Cut: Flat bottomed groove in the face of the
workpiece made with a dado blade.
Featherboard: Device used to keep a board
against the rip fence or table that allows the
operator to keep hands away from the saw blade.
Kerf: The resulting cut or gap made by a saw
blade.
Kickback: An event in which the workpiece is lifted
up and thrown back toward an operator, caused
when a work piece binds on the saw blade or
between the saw blade and rip fence (or other fixed
object). To minimize or prevent injury from
kickbacks, see the Operating Instructions section.
Miter Gauge: A component that controls the
workpiece movement while performing a crosscut
of various angles.
Non-Through Cut: A sawing operation that
requires the lowering of the splitter and removal of
the blade guard and kick-back pawls, resulting in a
cut that does not protrude through the top of the
workpiece (includes Dado and rabbet cuts).
The blade guard and kick-back pawls must be re-
installed and splitter raised after performing a non-
through cut to avoid accidental contact with the
saw blade during operation.
Parallel: Position of the rip fence equal in distance
at every point to the side face of the saw blade.
Perpendicular: 90° (right angle) intersection or
position of the vertical and horizontal planes such
as the position of the saw blade (vertical) to the
table surface (horizontal).
Push Board/Push Stick: An instrument used to
safely push the workpiece through the cutting
operation.
Rabbet: A cutting operation that creates an
L-shaped channel along the edge of the board.
Rip Cut: A cut made along the grain of the
workpiece.
Splitter: Metal plate to which the blade guard is
attached that maintains the kerf opening in the
workpiece when performing a cutting operation.
Standard Kerf: 1/8" gap made with a standard
blade.
Straightedge: A tool used to check that a surface
is flat or parallel.
Through Sawing: A sawing operation in which the
workpiece thickness is completely sawn through.
Proper blade height usually allows a 1/8" of the top
of the blade to extend above the wood stock.