Filter
Top Products
29
Figure 44
5. Referring to Figure 45:
6. Remove the black plastic cap (B) from the side
of the motor (C).
7. Carefully remove the spring-loaded cap, and
then pull out the brush and replace.
8. Replace the other side.
9. The ears on the metal end of the assembly go in
the same hole the carbon part fits into. Do not
overtighten the plastic cap.
10. Carefully set the saw in an upright position on a
clean level surface.
11. Replace the blade guard, blade, rip fence, miter
gauge and stand assembly to the table saw.
Note: To reinstall the same brushes, first make sure
the brushes go back in the way they came out. This
will avoid a break-in period that reduces motor
performance and increases wear.
Figure 45
Lubrication
All motor bearings are permanently lubricated at the
factory and require no additional lubrication.
On all mechanical parts of your table saw where a
pivot or threaded rod is present, lubricate using
graphite or silicone. These dry lubricants will not hold
sawdust as would oil or grease.
Push Stick Construction
Use solid wood or good quality plywood to construct
a push stick using the template below. The push
stick must be thinner than the width of the material
being cut.
Figure 46