Filter
Top Products
8
Assembl
y
Base and Column Assembly
Referring to Figure 1:
1. Place the base (D) on a level floor.
2. Place the column assembly (E) on the base (D)
and align the holes in the column support with
the holes in the base.
3. Using a 5/8-in wrench, secure the column (E)
with four M10 x 30 hex cap screws (O) to the
base.
Table and Rack
Referring to Figure 2:
When shipped, the rack ring (E
1
) and rack (E
3
) are
bundled together with the column (E) in plastic wrap.
1. Remove the wrap and take the rack ring (E
1
)
and rack (E
3
) off the column (E). Note which
end of the rack is up. It must be reinstalled later
with the same side up.
2. Place the rack (E
3
) inside the table bracket (C)
such that the teeth of the rack (E
3
) mesh with
the pinion gear on the end of the table crank
handle shaft (C
1
).
3. Slide the bracket assembly (C) together with
the rack (E
3
) onto the column (E) as shown.
4. Place the rack ring (E
1
) onto the column (E),
sliding it down so it rests against the rack (E
3
)
as shown and tighten the setscrew (E
2
) with a
3mm hex wrench (provided).
5. Place the table (B) onto the table bracket (C),
positioning it as shown in Figure 2. Secure
table with table lock handle (L).
6. Secure the table extension (B
1) with two table
extension lock knobs (Q).
Table Height Adjust and Column Lock
Handles
Referring to Figure 2:
1. Loosen the setscrew (R
1) on the table height
adjust handle (R).
2. Slide the handle (R) onto the table bracket shaft (C
1).
3. Turn the handle (R) until the setscrew (R
1) is
on the flat section of the shaft (C
1) and tighten
the setscrew (R
1) with a 3mm hex wrench to
secure the handle.
4. Thread the column lock handle (K) into the
back side of the table bracket (C) opposite the
height adjust handle (R).
Figure 1
Figure 2