Filter
Top Products
Electrical
Grounding Instructions
This jointer must be
grounded while in use to
protect the operator from electric shock.
In the event of a malfunction or breakdown,
grounding provides a path of least resistance for
electric current to reduce the risk of electric
shock. This tool is equipped with an electric
cord having an equipment-grounding conductor
and a grounding plug. The plug must be
plugged into a matching outlet that is properly
installed and grounded in accordance with all
local codes and ordinances.
Do not modify the plug provided. If it will not fit
the outlet, have the proper outlet installed by a
qualified electrician. Improper connection of the
equipment-grounding conductor can result in a
risk of electric shock. The conductor, with
insulation having an outer surface that is green
with or without yellow stripes, is the equipment-
grounding conductor. If repair or replacement of
the electric cord or plug is necessary, do not
connect the equipment-grounding conductor to a
live terminal.
Check with a qualified electrician or service
personnel if the grounding instructions are not
completely understood, or if in doubt as to
whether the tool is properly grounded. Use only
three wire extension cords that have three-prong
grounding plugs and three-pole receptacles that
accept the tool’s plug.
Repair or replace a damaged or worn cord
immediately.
115 Volt Operation
Referring to Figure 9:
As received from the factory, your Woodworking
Jointer is ready to run at 115-volt operation. This
Woodworking Jointer, when wired for 115 volt, is
intended for use on a circuit that has an outlet
and a plug that looks like the one illustrated in
(A). A temporary adapter, which looks like the
adapter shown in (B), may be used to connect
this plug to a two-pole receptacle if a properly
grounded outlet is not available.
Figure 9
The temporary adapter should only be used until
a properly grounded outlet can be installed by a
qualified electrician. This adapter is not
applicable in Canada. The green colored rigid
ear, lug, or tab, extending from the adapter,
must be connected to a permanent ground such
as a properly grounded outlet box.
230 Volt Operation
Referring to Figure 10:
If 230V, single-phase operation is desired, the
following instructions must be followed:
1. Disconnect the machine from the power
source.
2. The JET Woodworking Jointer motor has
four numbered leads that are factory
connected for 115V operation, as shown in
(A). For 230V operation reconnect the leads
as shown in (B).
3. The 115V attachment plug (C) supplied with
the Woodworking Jointer must be replaced
with a UL/CSA listed plug suitable for 230V
operation (D). Contact your local Authorized
JET Service Center or qualified electrician
for proper procedures to install the plug.
The Woodworking Jointer must comply with
all local and national codes after the 230-volt
plug is installed.
4. The Woodworking Jointer with a 230-volt
plug should only be connected to an outlet
having the same configuration as shown in
(D). No adapter is available nor should be
used with the 230-volt plug.
Figure 10