Filter
Top Products
13
Installing Access Cover
1. Install access cover by placing bottom of panel
into access in stand and fastening by turning
latch (Fig. 17).
If the access door latch needs adjustment:
1. Remove the access door from the stand.
2. Loosen the hex lock nut (A, Fig. 17). Rotate
the latch a quarter turn clockwise to tighten and
counterclockwise to loosen.
3. Tighten the lock nut (A, Fig. 17).
4. Re-install the access door.
Installing Dust Chute
1. Attach the dust chute (Fig. 18) to the stand
with four screws and four flat washers, through
the pre-tapped holes in the stand.
Electrical Connections
WARNING
All electrical connections must be done by
a qualified electrician! Failure to comply
may result in serious injury!
Remove the cover of the electrical box (A, Fig. 19)
and mount the box to the right side of the stand
using the two screws provided. Insert the motor
leads through the hole in the stand as shown, and
insert a grommet (B, Fig. 19).
Consult the wiring diagram on page 28 when wiring.
The JJ-8CS jointer is rated at 230V, single phase
only. Confirm that the power at the source is com-
patible with the jointer before inserting plug into the
outlet. The jointer is designed to be used with a
plug and outlet as in Fig. 20.
Important: Make certain the receptacle in ques-
tion is properly grounded. If you are not sure,
have a registered electrician check the recep-
tacle.
Fig. 17
Fig. 18
Fig. 19
Fig. 20