Filter
Top Products
8
Installing Bed to Stand
1. Use an assistant or hoist mechanism to place
bed assembly on top of stand. Be sure identi-
fication label on the bed faces the same direc-
tion as the label on the stand (Fig. 1).
2. Line up two holes in top of stand with holes in
bed assembly by viewing through access door
in stand.
3. Attach bed assembly to stand with two 3/8"
lock bolts and lock washers (Fig. 2). Hand
tighten only at this time.
4. Line up third hole in stand with hole in bed as-
sembly by viewing through dust chute.
5. Install third 3/8" lock bolt and lock washer
through dust chute to secure bed to stand.
6. Tighten all three mounting bolts with 14mm
wrench.
Installing Handwheels
1. Remove protective tape from shaft, and remove
screw and washer.
2. Press handwheel (A, Fig. 3) onto shaft, align-
ing the key way with the key. If necessary, use
a hammer with a block of wood to tap the
handwheel completely onto the shaft.
3. Re-install screw and washer (B, Fig. 3).
4. Mount handle (C, Fig. 3) onto handwheel.
Fig. 1
Fig. 2
Fig. 3