Filter
Top Products
13
IMPORTANT: When moving the pulleys, do
not position them beyond the end of the
shaft. Both pulleys must fully engage the
shaft and the key.
7. Open the lower door, and place the v-belt
around the motor pulley and the wheel
pulley (see Figure 13).
8. Loosen the nuts on the four motor mounting
bolts (Figure 15) and tension the v-belt by
pushing down on the motor. Tighten the four
motor mounting nuts.
9. The v-belt is properly tensioned when finger
pressure between the two pulleys causes
approximately 1/2" deflection (Figure 16).
10. Screw the two small knobs (Figure 17) into
the threaded holes in the saw body. Slide
the pulley cover down over the knobs, and
tighten the knobs.
11. Attach trunnion support bracket to saw body
with two M8 x 30 hex cap screws and two
M8 lock washers, as shown in item D, page
8. See Figure 18.
12. Thread nut onto table stop bolt (Figure 18)
and attach to trunnion support bracket as
shown.
Figure 15
Figure 16
Figure 17
Figure 18