Jet Tools JWBS-14CS Saw User Manual


 
7
Unpacking – JWBS-14OS
Open shipping container and check for shipping damage. Report any damage immediately to your
distributor and shipping agent. Read the instruction manual thoroughly for assembly, maintenance and
safety instructions.
Contents of the Shipping Container
1 Stand top with motor support plate
4 Stand legs
2 Cross braces-short
2 Cross braces-long
1 Stand support plate
1 Saw body
1 Table
1 Motor
1 V-belt
1 Pulley cover
2 Table lock knobs
1 Table pin
1 Trunnion support bracket
1 Fastener package (see below)
1 Instruction Manual
1 Warranty Card
Fasteners
A. Stand Assembly (partial quantity shown)
40 – M8x16 carriage bolts
40 – M8 flat washers
40 – M8 lock washers
40 – M8 hex nuts
B. Saw Body to Stand
4 – M8x40 hex cap screws (approx. 1-1/2")
8 – M8 flat washers
4 – M8 lock washers
4 – M8 hex nuts
C. Motor to Stand
4 – M8x35 hex cap screws (approx. 1-3/8”)
8 – M8 flat washers
4 – rubber grommets
4 – M8 lock washers
4 – M8 hex nuts
D. Pulley Cover to Stand
3 – M5x12 pan head screws (approx. 1/2”)
6 – M5 flat washers
3 – M5 hex nuts
E. Trunnion Support Bracket to Saw Body
2 – M8x30 hex cap screws (approx. 1-1/4")
2 – M8 lock washers
1 – M8x80 hex cap screw (for table stop -
approx. 3-1/8” long)
1 – M8 hex nut (for table stop)