Filter
Top Products
1/2-Inch Drill Operator's Manual 7
OUTDOOR USE EXTENSION CORDS
When tool is used outdoors, use only extension cords intended for use outdoors and
so marked.
STAY ALERT
Watch what you are doing. Use common sense. Do not operate tool when you are
tired.
CHECK DAMAGED PARTS
Before further use of the tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving parts, breakage of
parts, mounting, and any other conditions that may affect its operation. A guard or
other part that is damaged should be properly repaired or replaced by a John Deere
Dealer unless otherwise indicated elsewhere in this instruction manual. Have
defective switched replaced by a John Deere Dealer. Do not use tool if switch does
not turn it on and off.
AVOID USING A POWER TOOL FOR APPLICATIONS OTHER THAN THOSE
SPECIFIED
Never use a power tool for applications other than those specified in the instruction
manual.
ENSURE SAFE OPERATION THROUGH CORRECT HANDLING
Secure safe operation through correct handling by observing the instructions de-
scribed herein. Do not employ accessories other than those specified herein;
otherwise, a hazardous condition may be created. Never allow a power tool to be
used by persons not familiar with correct handling (such as children) or by those who
cannot handle the tool correctly.
CONFIRM THAT NO ITEMS SUCH AS AN ELECTRIC CABLE OR CONDUIT ARE
BURIED INSIDE
In places where live wiring may be hidden behind a wall, floor, ceiling, etc. do not hold
or contact any metal parts of the tool. In such cases, metal parts could become
electrically live and present a serious shock hazard.
KEEP THE RIGHT PARTS IN THE RIGHT POSITION
Do not remove covers and screws which have been factory-mounted. They perform
important respective roles. Keep them in the right positions.
SHOULD THE PLASTIC HOUSING OR HANDLE OF A POWER TOOL BE
CRACKED OR DEFORMED, DO NOT USE IT
Since cracked or deformed parts may lead to an operator receiving an electric shock,
do not use such a power tool. Immediately have it repaired.
CAUTION