John Deere AC-G7510H Welding System User Manual


 
24 Operator’s Manual
GENERATOR MAINTENANCE
EVAPORATIVE EMISSION COMPONENTS:
The unit you have purchased includes the following
components that are in compliance with California Air
Resources Board Evaporative Emission Standards;
1. Fuel Hose
2. Fuel Hose Fittings
3. Fuel Tank and Cap
4. Carbon Canister and Mounting Brackets
These components should be inspected on a daily basis
for cracks, leaks, and abnormal wear. If cracking, leaks
or abnormal wear has occurred, the components should
be replaced immediately.
IDLE CONTROL ADJUSTMENT:
NOTE: The automatic idle speed is set between 2640
and 2940 RPM.
The idle speed has been pre-set at the factory and
should rarely require readjustment. We recommend that
all adjustments of this nature be made by a John Deere
Customer Service Representative.
Erratic idle operation of the engine usually indicates a
need for carburetor adjustment to provide a smooth idle.
The idle control will not function properly when the idle
speed is below the recommended limits or the carburetor
is improperly adjusted.
HAVE THE UNIT SERVICED BY AN AUTHORIZED
JOHN DEERE CUSTOMER SERVICE REPRESENTA-
TIVE.
Service