Filter
Top Products
system with easy access to the connections that it needs for power, local
communications, and remote communications.
WARNING: Two people are required to lift the system.
CAUTION: To prevent electrostatic damage to the system and its components, make
sure persons handling the system wear an antistatic device.
Rack-Mounted Installation
We recommend that you use a standard EIA distribution rack. See “Equipment Rack
Requirements” on page 46 for rack information.
Installation Guidelines
Before installing the systems in a rack, consider the following guidelines:
■ You can install several models in a single 7-ft. (2.1-m) rack. Installing multiple
systems in a single rack enables you to maximize your available space.
■ Install heavier systems on the bottom of the rack. Mount lighter systems higher
in the rack.
Preparing the Equipment Racks
Following your installation plan, use a tape measure and marking pen to measure
and mark space on each equipment rack for each system component. For horizontal
spacing follow Network Equipment Building System (NEBS) requirements.
Installing the System
To complete the installation of the system in a rack, you need:
■ A Phillips screwdriver
■ Eight 10-32 x 3/8 Phillips screws (provided) for each model to be installed
To install the system in the rack:
14 ■ Rack-Mounted Installation
C2000 and C4000 1.0.x Hardware Guide