Filter
Top Products
USING THE AIR COMPRESSOR
TIRE INFLATION
1.Open the small compartment on the rear of the unit and pull out the air hose.
2.Push the connector onto the tire’s valve stem as far as possible and press the
thumb lock to hold it in place.
3.Turn on compressor.
4.Watch the pressure gauge. Be careful not to over-inflate the tire.
5.When the proper air pressure is reached, turn off the compressor.
6.Open the thumb lock and pull the connector free of the valve stem.
7.Return air hose to storage compartment. Always leave the thumb lock open
when air hose is not in use.
1413
ALWAYS disconnect the clamp connected to the vehicle
frame or engine FIRST.
USING THE 12V POWER SUPPLY
DO NOT use this product with appliances that draw more
than 8 amps.
To use this unit as a power supply, simply plug your appliance’s 12V DC connector
into the DC accessory outlet and turn on the appliance.
USING THE WORK LIGHT
The emergency work light is located on the upper right corner of the jump-starter.
To operate, push the ON/OFF switch. When the unit is fully charged, this work light
will provide over 100 hours of illumination. ALWAYS turn the work light off before
charging or storage.