Filter
Top Products
9
The battery pack and charger heat during charging. Place the charger on a flat,
non-flammable surface away from flammable materials with at least four inches of
clearance to allow proper air circulation around the charger and battery pack.
When the battery pack requires recharging, a 3-5 hour charge allows the tool to
operate at full power. A charging indicator light on the charger will illuminate to
show that charging is taking place.
CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Make sure the trigger on
the Cordless Reciprocating
Saw is in the “OFF”
position and remove
the battery pack
from the Cordless
Reciprocating Saw.
2. Plug 120V AC Adapter into
household outlet and into
side of battery charger.
Insert battery pack into
battery charger. LED light
will turn green when
battery pack is fully
charged (approx. 3 hours).
3. When fully charged, reattach battery pack onto Cordless Reciprocating Saw,
making certain latches fasten securely. Cordless Reciprocating Saw will not
operate properly if the battery pack is not seated properly.
10
REMOVING / ATTACHING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release
buttons on either
side of the Cordless
Reciprocating Saw to
release the battery pack.
2. Pull battery pack free of
Cordless Reciprocating Saw.
ATTACH BATTERY PACK:
1. Align the raised portion of the battery pack
with the groove in the battery compartment
of the Cordless Reciprocating Saw.
2. Press the battery pack into place. Make sure the latches are securely fastened.
Do not use the Cordless Reciprocating Saw if the battery pack is not seated
properly.
CHARGER
Before using battery charger, please read carefully all
instructions and cautionary markings on battery charger, battery pack and
product using battery.
The charger will not automatically turn “OFF” when the
battery pack is fully charged. The charging indicator light will remain “ON”
until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as
listed in this manual. Do not substitute any other charger. Use only Alltrade
approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet
or damp environments, or immersed in liquid.
RELEASE BUTTON
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
BATTERY
CHARGER