Filter
Top Products
TThhee MMiitteerr SSaaww mmuusstt bbee ffiirrmmllyy mmoouunntteedd ttoo aa wwoorrkkbbeenncchh oorr ootthheerr ssttuurrddyy wwoorrkk ssuurr--
ffaaccee bbeeffoorree uussee..
Once the mounting location is selected, attach the saw to the
bench with wood screws.
IIff aa mmoorree ppoorrttaabbllee mmoouunnttiinngg ssiittee iiss ddeessiirreedd,, tthhee ssaaww mmaayy bbee aattttaacchheedd ttoo aa 33//44""
ppiieeccee ooff ppllyywwoooodd..
Make sure all four mounting feet are securely anchored to the
plywood. Before using saw, clamp the plywood to sawhorses or other stationary
mounting surfaces. Make sure the location is firm and level and allows enough
room to safely maneuver the workpiece.
Table extensions must be installed before mounting saw.
LLAASSEERR GGUUIIDDEE
Use of controls or procedures, or performance of proce-
dures other then those specified herein may result in hazardous radiation
exposure.
7. Push the arms through the second set of holes until the ends touch the base
of the saw.
8. Carefully tighten the bar clamp screws until the table extensions are held firmly
in place. Turn the lock nuts clockwise to keep the screw from loosening.
9. Repeat Steps 4 through 8 for the table extension on the other side.
10.Unfasten the saw and carefully lower it down onto the workbench.
AATTTTAACCHHIINNGG TTHHEE VVIISSEE
Position the grip-plate as
shown and insert the vise
inside the vise mounting
hole.
MOUNTING THE SAW
DO NOT use the Miter Saw until it is securely mounted.
An unmounted saw may shift or move unexpectedly during use, causing
personal injury and/or property damage.
15
16
FENCE BRACKET
TABLE EXTENSION
WING SCREW
ASSEMBLING THE TABLE EXTENSIONS
ATTACHING THE VISE
MOUNTING THE SAW
BAR CLAMP
GRIP-PLATE