Filter
Top Products
REMOVING / ATTACHING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release
buttons on either
side of the Cordless
Reciprocating Saw to
release the battery pack.
2. Pull battery pack free of
Cordless Reciprocating Saw.
ATTACH BATTERY PACK:
1. Align the raised portion of the battery pack
with the groove in the battery compartment
of the Cordless Reciprocating Saw.
2. Press the battery pack into place. Make sure the latches are securely fastened. Do
not use the Cordless Reciprocating Saw if the battery pack is not seated properly.
CHARGER #690072 / ADAPTER #690074
Before using battery charger, please read carefully all
instructions and cautionary markings on battery charger, battery pack and
product using battery.
The charger will not automatically turn “OFF” when the
battery pack is fully charged. The charging indicator light will remain “ON”
until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as
listed in this manual. Do not substitute any other charger. Use only Alltrade
approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet
or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
non-flammable surface away from flammable materials with at least four inches of
clearance to allow proper air circulation around the charger and battery pack.
When the battery pack requires recharging, a 3-5 hour charge allows the tool to
operate at full power. A charging indicator light on the charger will illuminate to
show that charging is taking place.
CHARGING BATTERY PACK USING CHARGER #690072 / ADAPTER #690074
CHARGE BATTERY PACK:
1. Make sure the trigger on
the Cordless Reciprocating
Saw is in the “OFF” posi-
tion and remove the battery
pack from the Cordless
Reciprocating Saw.
2. Insert the battery pack into
the charger. Be sure that
the battery pack is fully
seated in the charger. Do
not force.
3. Plug the charger into the
nearest 120 volt, electrical
outlet. The indicator light will come “ON”.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your Cordless Reciprocating Saw continuously, the batteries in your
battery pack will become hot. You should let a hot battery pack cool down for
approximately 30 minutes before attempting to recharge. When the battery pack
becomes discharged and is hot, the red light on the charger will flash. When the bat-
tery pack cools down, the red light will glow continuously.
This will occur when continuous use of your Cordless
Reciprocating Saw causes the battery pack to become hot. It does not occur
under normal circumstances.
ONE HOUR CHARGER #690507
Before using battery charger, please read carefully all
instructions and cautionary markings on battery charger, battery pack and
product using battery.
Use only the charger which accompanied your product or direct replacement as
listed in this manual. Do not substitute any other charger. Use only Alltrade
approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet
or damp environments, or immersed in liquid.
1211
RELEASE BUTTON
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
BATTERY
CHARGER