Filter
Top Products
ATTACHING / REMOVING BLADE
Failure to remove the battery pack from the saw before
removing the blade could result in accidental starting and serious personal
injury.
• Remove the battery pack.
• Use the allen wrench to loosen the blade clamp screw on the side of the saw by
turning it counter-clockwise. Do not remove the screw entirely.
TO ATTACH BLADE:
• Press the hole in the shank of the blade onto the pin in the saw bar. Make sure
that the teeth of the blade are facing downward.
• Tighten the blade clamp screw
back into place.
• Remove allen wrench.
• Replace the battery pack.
TO REMOVE BLADE:
• Pull the hole in the shank of the blade off the pin in the saw bar.
• Tighten the blade clamp screw back into place.
• Remove allen wrench.
• Replace the battery pack.
14
The battery pack and charger heat during charging. Place the charger on a flat,
non-flammable surface away from flammable materials with at least four inches of
clearance to allow proper air circulation around the charger and battery pack.
When the battery pack requires recharging, a 1 hour charge allows the tool to
operate at full power. A charging indicator light on the charger will illuminate to
show that charging is taking place.
CHARGING BATTERY PACK USING ONE HOUR CHARGER #690507
CHARGE BATTERY PACK:
1. Plug the charger into the nearest
120 volt electrical outlet. The
step of the battery has positive
and negative terminal markings
on it. Align the markings with
the identical markings on the top
of the charger base. Insert the
battery pack into base. Pack will
not insert properly if reversed.
2. Make sure the trigger on the
Cordless Reciprocating Saw is in
the “OFF” position and remove
the battery pack from the
Cordless Reciprocating Saw.
3. If, when first inserting the battery pack, the red “ON” button does not light up,
press the “SET” button on the charger. When the battery is charging, the red
light is “ON”.
4. After approximately one hour of charging, the red indicator light should go
“OFF” and the green light should come “ON”. The green light indicates that the
battery is fully charged.
5. When fully charged, reattach battery pack onto Cordless Reciprocating Saw,
making certain latches fasten securely. Cordless Reciprocating Saw will not oper-
ate properly if the battery pack is not seated properly.
ASSEMBLY
Be aware that this tool is always in an operating condition
because it does not have to be plugged into an electrical outlet. Always turn
the switch “OFF” and remove the battery pack before changing blades.
13
BLADE CLAMP
BATTERY PACK
BATTERY
CHARGER