Filter
Top Products
• Put on eye protection.
• Clear the saw of any foreign material.
• Make sure the work piece is held
securely in place. Hold smaller pieces
in a vise or attach to the workbench
with clamps.
• Mark out the line to be cut so it is easily visible.
• Pull the trigger to start the saw.
• Set the shoe against the work piece.
• When the blade reaches full speed, slowly feed the blade into the work piece.
PLUNGE CUTTING
Never feed the blade into the work piece until the blade
is at full speed. If the blade is not at full speed, the saw may kick back
causing serious personal injury.
• Mark out the line to be cut so it is easily visible.
• Start inside the area to be cut out.
• Depress the lock-on button and press the trigger
to start the saw.
16
OPERATING THE RECIPROCATING SAW
Never tape the trigger switch down to provide continuous
high speed. The tool may fail under such conditions causing fire or personal
injury.
The lock-off button helps prevent accidental starting. This
button can be pressed from either side.
VARIABLE SPEED TRIGGER SWITCH
THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
• The speed of the Cordless Reciprocating Saw
depends on the amount of pressure applied on
the trigger. The further the trigger is pressed, the
faster the tool will go.
• Press the lock-off button, then pull the “ON/OFF” trigger to turn the Cordless
Reciprocating Saw “ON”. To turn the Cordless Reciprocating Saw “OFF”,
release the trigger switch.
GENERAL CUTTING
Always hold the saw in front of you and away from your body. Keep your
hands and feet well away from the work piece.
Never feed the blade into the work piece until the blade is at full speed.
If the blade is not at full speed, the saw may kick back causing serious
personal injury.
Use proper blade for the particular cutting application.
15
TRIGGER
SWITCH
LOCK-ON
BUTTON