Filter
Top Products
LLOOCCAATTIIOONN
Position the Arc Welder on a secure level surface in a dry location where there is
free circulation of clean air. Ensure all air passages are clean and free of obstruc-
tions. Blocked air passages can cause the Arc Welder to overheat.
UUNNPPAACCKKIINNGG
All welding accessories (except for the welding helmet and leather gloves) are
stored inside the wire feed compartment on the top of the welder. Lift and remove
the wire feed cover to find the handle, work clamp, grounding cable, and wire spool.
AASSSSEEMMBBLLYY
DDiissccoonnnneecctt tthhee ppoowweerr pplluugg ffrroomm tthhee AACC
ppoowweerr ssoouurrccee bbeeffoorree aannyy aasssseemmbbllyy,, aaddjjuussttmmeennttss,, oorr
aaddd
diinngg//rreemmoovviinngg aacccceessssoorriieess..
Following this preventative step
reduces the risk of the Arc Welder coming on accidentally and the
risk of damage to the workpiece and injury to the operator.
AATTTTAACCHH HHAANNDDLLEE::
1.Place the handle (1) on top of the cover.
2.Secure the handle, using the screws and washers (2).
10
9
FFUUNNCCTTIIOONNAALL DDEESSCCRRIIPPTTIIOONN
CCOONNTTRROOLLSS AANNDD CCOOMMPPOONNEENNTTSS::
1. Welder
2. Torch
3. Overload Indicator
4. Power Switch
5. Wire Speed Control
6. Amperage Selection Switch
7. Ground Cable
8. Power Cord
9. Helmet
TThhiiss aarrcc wweellddeerr rreeqquuiirreess aa ddeeddiiccaatteedd 112200VV//6600 HHzz -
-
3300 AAMMPP cciirrccuuiitt aatt ““MMaaxx”” aammppeerraaggee sseettttiinngg oorr 2200 AAmmpp cciirrccuuiitt aatt ““MMiinn””
aammppeerraaggee sseettttiinngg ttoo ffuunnccttiioonn ppr
rooppeerrllyy..
Do not run other lights, appli-
ances, or tools on this circuit while the Arc Welder is in operation. Failure
to comply with this CAUTION will result in tripped circuit breakers and/or
blown fuses.
AACCCCEESSSSOORRIIEESS::
10. Wire Reel Washer and Wing Nut
11. Flux Core Wire
12. Wire Brush/Hammer
13. Contact Tip
14. Leather Welding Gloves
15. Wrench
2
1
2
3
1
2
4
5
6
9
15
13
7
11
10
8
12
14