Filter
Top Products
CCHHAARRGGIINNGG BBAATTTTEERRYY PPAACCKK
CCHHAARRGGEE BBAATTTTEERRYY PPAACCKK::
1. Plug the charger into
the nearest 120 volt
electrical outlet.
2. Make sure the trigger
on the Cordless
Reciprocating Saw
is in the
““OOFFFF””
position and remove
the battery pack
from the Cordless
Reciprocating Saw.
3. Insert the battery pack
into the charger. Be sure that the battery pack is fully seated in the charger. Do
not force.
4. The red indicator light should come
““OONN””
indicating that the battery pack is in
a “Fast Charge” mode. If the green indicator light comes
““OONN””
, then the battery
is already fully charged.
5. After approximately one hour of charging, the red indicator light should go
““OOFFFF””
and the green light should come
““OONN””
indicating that the battery is fully
charged and the charger is now in a “Trickle Charge” mode.
6. The battery can be left in a “Trickle Charge” mode until ready to use.
IIMMPPOORRTTAANNTT
IINNFFOORRMMAATTIIOONN FFOORR RREECCHHAARRGGIINNGG HHOOTT BBAATTTTEERRIIEESS
When using your Cordless Reciprocating Saw continuously, the batteries in your
battery pack will become hot. You should let a hot battery pack cool down for
approximately 30 minutes before attempting to recharge. When the battery pack
becomes discharged and is hot, the red light on the charger will flash. When the
battery pack cools down, the red light will glow continuously to indicate fast
charging mode, 1-hour charge time.
TThhiiss wwiillll ooccccuurr wwhheenn ccoonnttiinnuuoouuss uussee ooff yyoouurr CCoorrddlleessss
RReecci
ipprrooccaattiinngg SSaaww ccaauusseess tthhee bbaatttteerryy ppaacckk ttoo bbeeccoommee hhoott..
It does not occur
under normal circumstances.
12
RREEMMOOVVIINNGG // AATTTTAACCHHIINNGG BBAATTTTEERRYY PPAACCKK
RREEMMOOVVEE BBAATTTTEERRYY PPAACCKK::
1. Press both release
buttons on either
side of the Cordless
Reciprocating Saw to
release the battery
pack.
2. Pull battery pack free of
Cordless Reciprocating Saw.
AATTTTAACCHH BBAATTTTEERRYY PPAACCKK::
1. Align the raised portion of the battery
pack with the groove in the battery com-
partment of the Cordless Reciprocating Saw.
2. Press the battery pack into place. Make sure the latches are securely fastened. Do
not use the Cordless Reciprocating Saw if the battery pack is not seated properly.
CCHHAARRGGEERR
BBeeffoorree uussiinngg bbaatttteerryy cchhaarrggeerr,, pplleeaassee rreeaadd ccaarreeffuullllyy aallll
iinnssttrruuccttiioonnss aanndd ccaauuttiioonnaarryy mmaarrkkiinnggs
s oonn bbaatttteerryy cchhaarrggeerr,, bbaatttteerryy ppaacckk aanndd
pprroodduucctt uussiinngg bbaatttteerryy..
UUssee oonnllyy tthhee cchhaarrggeerr wwhhiicchh aaccccoommppaanniieedd
yyoouurr pprroodduucctt oorr ddiirreecctt rreeppllaacceemmeenntt aass
lliisstteedd iinn tthhiiss mmaannuuaall..
Do not substitute any other charger. Use only Alltrade
approved chargers with your product.
DDoo nnoott ddiissaasssseemmbbllee cchhaarrggeerr..
DDoo nnoott u
ussee cchhaarrggeerr iiff iitt hhaass bbeeeenn ddaammaaggeedd,, lleefftt oouuttddoooorrss iinn tthhee rraaiinn,, ssnnooww,, wweett
oorr ddaammpp eennvviirroonnmmeennttss,, oorr iimmm
meerrsseedd iinn lliiqquuiidd..
TThhee bbaatttteerryy ppaacckk aanndd cchhaarrggeerr hheeaatt dduurriinngg cchhaarrggiinngg..
Place the charger on a flat,
non-flammable surface away from flammable materials with at least four inches of
clearance to allow proper air circulation around the charger and battery pack.
WWhheenn tthhee bbaatttteerryy ppaacckk rreeqquuiirre
ess rreecchhaarrggiinngg,, aa 11 hhoouurr cchhaarrggee aalllloowwss tthhee ttooooll ttoo
ooppeerraattee aatt ffuullll ppoowweerr..
A charging indicator light on the charger will illuminate to
show that charging is taking place.
11
BATTERY PACK
LED
LIGHT
BATTERY
CHARGER
RELEASE
BUTTON