Filter
Top Products
10-5508 Rev A Service Department (800) 888-70096
push on board, pull on wire
Pull each of the four wires back out the hole one by one. Save the rubber
grommet.
There are four steps to Allenair® valve installation:
1 Adjust and mount new valve
2 Install single to double splitter and electrical wires
3 Secure and tie wires and replace lid
4 Test compressor
5
Note: Keep two things in mind when you are ready to install the new valves.
First, the new valve requires a different mount. Second, the electrical wiring requires the
installation of a single to double adapter on the circuit board.