Filter
Top Products
INSTALLCOVERS
After installing your water softener, replace the covers. Angle
the covers so the main cover clips onto the back first, then
bring down in front and clip on the two (2) tabs inside the rim
of the salt hole and lower the salt cover closed. See Fig. 23.
RESTART THE WATER HEATER
Turn on the gas (or electric) supply to the water heater and
light the pilot.
YOUR PLUMBING INSTALLATION AND ELECTRICAL
WORK ARE NOW COMPLETE.
Cover
(Main)
Salt Hole
Cover
FIG. 23
Salt Level Adjust Display
REGENERATION Button
UP Button
Signal Light
Adjust
DOWN Button
Tank Light
PROGRAM THE TIMER
1. When the transformer is plugged in, the model code H 32,
and a test number (example: J1.1) show in the face plate
display for 4 seconds. Then, 12:00 AM and PRESENT
TIME begin to flash.
NOTE: If '; - - -" shows in the display, press the UP or
DOWN button until either H 32, for model 38376, or
H 33, for model 39376, shows in the display. Then,
press the SELECT button to set, and change to the
flashing PRESENT TIME display.
2. To check the model code, unplug the transformer at the
wall outlet and plug in again. If other than this code
shows, refer to the Troubleshooting Section.
SOUND "BEEPER": A "beeper" sounds while pressing
buttons for timer setup. One beep signals a change in the
face plate display. Repeated beeps mean the timer will not
accept a change from the button you have pressed, telling
you to use another button. For example, while setting the
hardness the beeper sounds repeatedly when the display
reaches 1 using the DOWN button, or the highest hard-
ness setting using the UP button.
SELECT Buttons
_ i_ I I -I -I
17 _-IC
I I I
_____ J J,J
_ i_ I I 7 -I
17 _7-I
I I I
_____ J J,J
FIG. 24
- -8- - IC,I_IU
PRESENT TIME
_ __ _
- -8- -
_ ___ _
i 7,1717 AM
IC ,I_IU
PRESENT TIME
FIG. 25
Questions? Call The Kenmore Water Line 1-800-426-9345
17