Filter
Top Products
ELECTRICAL REQUIREMENTS
Electrical Shock Hazard
- Electrical ground is required on this appliance.
- Improper connection of the equipment-grounding conductor line can result in electrical shock.
- Check with a qualified electrician if you are in doubt as to whether the appliance is
properly
grounded. *
. Do Not have a fuse in the neutral or ground circuit. A fuse in the neutral or ground circuit could
result in an electrical shock.
. This appliance must be connected to a grounded, metallic permanent wiring system; or a
grounding conductor should be connected to the grounding terminal or lead on the
appliance. Failure to do so could result in an electrical shock.
It is the customer’s responsibility to contact a qualified electrical Installer to assure that electrical installation is
adequate and in conformance with National Electrical Code, ANSVNFPA 70-latest edition
and local codes and ordinances.
A 120/240-volt or 120/208-volt, 60 Hz, AC only, fused electrical supply is required. A time-delay fuse orcircuit breaker
is recommended. It is recommended that a separate circuit serving only this appliance be provided.
The
junctron box for standard dwellings must
be supplied with srngle phase, 3 wrre. 120/240 volt, or 120/208 volts, 60
hertz, AC
current.
For a mobile home, the box must be suppl~ed with 4 wares instead of 3 in accordance with the National
Electrical Code (Article 556.9)
-24 MIN-
InsIde of back
ttom of
CrOWaYe --
en Cav1ry
-28~112 -
------
1 To Top 01
11 Oven
1 Supporr
I-
1
50
-i-
5
40
t
Fig. 1
The following amperage circuits must be provided
Models
Amps
KEMS 375
40 amps
KEMI 375
KECO 375MS
CMO 2743
-27 MIN---
-24-l .!2 -
Elecrr~c
Junction Box
bv Installer
=
4
49
/
,‘,-
I
-
,
61 I
9
-
bllN
‘Minimum height for botrom of
cutout. This places InsIde of
mIcrOwave oven cavity 40”
above floor.
KECO 376MCS 30 amps
KEMS 376